Hello all,
So I am trying something new and am using a power module so I can select btwn 120 and 220v w/o breaking out the tools.
Here is the spec on the module:
http://www.mouser.com/ds/1/337/76300001-11868.pdf
The transformer I am using is one from Trafomatic and the four mains are labeled 1 thru 4.
for 120V:
connect 1 & 3 to LINE
2 & 4 to NEUTRAL
For 220v
Connect 1 to Line
4 to Neutral
connect 2 & 3 together
On the qulatek module I connected LIVE to "A" (on PDF on Mouser site bottom left corner - couldnt figure out how to attach a pdf)
NEUTRAL to 'C'
Wires 1 - 4 to their respective posts and then
post 4 to 'D'
Post 1 to 'B'
Did I do this correctly?
Doing this w/o the module is flippin easy and I am really rethinking the whole module bit but I've cut the hole...
Any help would be greatly appreciated...logic diagrams make Mongo head hurt.
Thanks
erick