MKIII noise issues
![Post Post](./styles/prosilver/imageset/icon_post_target.gif)
I hooked up the MKIII to my scope and test load. The input consisted of my generator through a volume pot into the input jack. I turned on the amp and let the tubes warm up a few minutes, then I adjust the bias slowly up to 1.4V. This setup is NOT using the balance pot and a single 10 ohm resistor for both tubes like the original. With the scope in the 20mV per division (P-P) I get about 18 mV wide band noise. The scope can not hone in on one frequency, when I shift the time base to look at the higher frequencies, the scope starts to pick out 50kHz through 80kHz noise. I installed an input jumper on the RCA jack and hooked up the amp to a speaker. I powered on and let the amp sit a few minutes to warm up and I verified the bias was 1.4V and I hear nothing at the speaker. I put my ear up to it and its pretty quiet. I took the cover off of the speaker to feel the woofer and there is no movement. I checked my connections to make sure everything was hooked up properly and it was. When I turned off the amp I heard a small pop out of the speaker so it was hooked up correctly. My question is, should I worry about this high frequency noise if it is inaudible? Is there anything you suggest I try short of desoldering the driver or power supply board? Thanks.
BTW this unit has the Bal omitted and is using the C. Chong power supply PCB.
BTW this unit has the Bal omitted and is using the C. Chong power supply PCB.