Mounting and tube hole locations for the Poseidon board

for Dynaco Mark II/III/IV and DIY PP monoblocks

Mounting and tube hole locations for the Poseidon board

Postby ashok » Wed Oct 31, 2012 9:48 am

Hi Shannon,

I just purchased a pair of the Poseidon boards. Would it be possible to get the locations of the mounting holes, and tube holes and their diameters?

My plan is to get Front Panel Express plates made for the build.

Thank you,

Ashok
ashok
 
Posts: 83
Joined: Sat Feb 21, 2004 12:39 am
Location: Lexington, MA

Postby Shannon Parks » Wed Oct 31, 2012 11:02 am

No problem, Ashok. If I don't post it tonight, I will in the morning.

Shannon
User avatar
Shannon Parks
Site Admin
 
Posts: 3764
Joined: Tue Mar 18, 2003 5:40 pm
Location: Poulsbo, Washington

Postby Shannon Parks » Thu Nov 01, 2012 4:41 am

Here you go, Ashok. One trick I do is to print a 1:1 from FPE and lay my bare board on it for a double-check.

Board Outline
4.375" by 3.250"

Mounting Holes (.130" dia)
500,62
3875,62
500,3187
3875,3187
187,565
187,2690
4188,2690
4188,565

Tube Holes (.750" with the small one piece ceramic)
3525,1625
1455,1625

Balance Pot Hole (not used on board - estimate of trimmer screw)
456,1469

Shannon
User avatar
Shannon Parks
Site Admin
 
Posts: 3764
Joined: Tue Mar 18, 2003 5:40 pm
Location: Poulsbo, Washington

Postby ashok » Thu Nov 01, 2012 6:29 am

Thank you Shannon. Much appreciated. I will make the FPE files available for the forum once I have created and verified them.

Ashok
ashok
 
Posts: 83
Joined: Sat Feb 21, 2004 12:39 am
Location: Lexington, MA


Return to poseidon

Who is online

Users browsing this forum: No registered users and 9 guests