Speaker terminal question

for Dynaco Mark II/III/IV and DIY PP monoblocks

Speaker terminal question

Postby Rex Everything » Fri May 20, 2011 9:11 pm

I recently received a pair of five way binding post for my Poseidon modded Mark III's and have a question on the correct way to hook them up. This is only one pair so the 4 & 16 ohm taps will just be heat shrinked.

My question is on the Poseidon board there is a connection going from "I" to the 16 ohm lug on the original Mark III speaker terminals. Since I won't be using the 16 ohm tap and do not have a terminal for it where should this lead coming from point "I" be connected to?
Rex Everything
 
Posts: 70
Joined: Sun Feb 22, 2009 6:26 pm
Location: Las Vegas

Postby TomMcNally » Fri May 20, 2011 10:15 pm

Connect the 16 ohm lead from the transformer to point I instead of heat shrinking it.
User avatar
TomMcNally
Darling du Jour
 
Posts: 2729
Joined: Sat Nov 19, 2005 2:19 pm
Location: Northfield, NJ

Postby Rex Everything » Fri May 20, 2011 10:20 pm

TomMcNally wrote:Connect the 16 ohm lead from the transformer to point I instead of heat shrinking it.


Thank you sir. Some times it's easy to miss the obvious ;)
Rex Everything
 
Posts: 70
Joined: Sun Feb 22, 2009 6:26 pm
Location: Las Vegas


Return to poseidon

Who is online

Users browsing this forum: No registered users and 14 guests