PSD II Question
Posted: Thu Sep 03, 2009 9:16 pm
Hi all,
I've apparently run way too many simulations and have tweaked way to many power supply values because my brain just locked up.
Using Duncan Amps PS II, should I be working my voltages to RMS or Peak values? I.E., when the original Mark III schematic shows a value of 480VDC at C2 behind the choke, it means RMS, right?
Jeez, I hate it when this happens.
Thanks,
Chris
I've apparently run way too many simulations and have tweaked way to many power supply values because my brain just locked up.
Using Duncan Amps PS II, should I be working my voltages to RMS or Peak values? I.E., when the original Mark III schematic shows a value of 480VDC at C2 behind the choke, it means RMS, right?
Jeez, I hate it when this happens.
Thanks,
Chris