I'm finally getting time to assemble a rev E board I purchased several years ago. I purchased parts from Mouser using the parts list cut & paste. I purchased both the 10K adjustable pots in the parts list and also the 100 ohm listed under the zener mod. for use in positions R19,R22,R25 & R28. When I assembled the board recently I installed the zener diodes in positions R18,R21,R24 & R27. I must have not been thinking and installed the 10K ohm adjustable pots in R19,R22,R25 & R28. I had the bag of 10K ones labeled for these positions (forgetting that I also had the 100 ohm parts too) and also when I looked at the schematic it shows 10K in these positions. I didn't catch my mistake until I went to set the bias and my ohm readings from pin 3 of V3,V4,V5 & V6 weren't even close to the 400 ohms in the instructions. My question is: what is the proper method for setting the bias with the zener mod? I assume the 100 ohm pots are the correct ones to use in these positions.
Thanks, Bill